Home Page  |  Contact Me  |  Transponder Chip Keys for Jeep Wrangler

Pilot Brand, 4 Inch, PL-360C Fog Light Kit Install on Jeep Wrangler JK

Pilot Automotive 4" Diameter, #PL360C, Clear Fog Lights Kit Installation in 2011 Jeep Wrangler

Pilot PL-360C Fog Lights in Box Front  Pilot PL-360C Fog Lights  Pilot PL-360C Fog Lights in Box Rear

Pilot Automotive Brand, 4 Inch Fog Light Kit PL360C

Pilot PL-360C Fog Light Bracket inside Jeep Wrangler JK Bumper

Fog Light Bracket inside bumper (after black spray paint.)  I removed the factory front bumper and removed the factory fog lights. There are 8 bolts that need to be removed when taking off the factory bumper. Since the bumper is half plastic, and half steel, it was a fairly easy job.  I then had to drill two holes in the top of the steel bumper to install the Pilot Fog Light Brackets. After the brackets were installed, I then spray painted the brackets and bolts black to help prevent rust. After the bumper is re-installed, the two bolts and nuts that hold the new Pilot Fog Light brackets are completely covered by the factory plastic on the bumper.


Pilot PL-360C Fog Light in Jeep Wrangler JK Bumper    JK Wrangler with Pilot PL360C Fog Lights    JK Wrangler with Pilot PL360C fog lights on

Fog lights installed in 2011, JK Jeep Wrangler


Phillips X-Treme Power H13 Headlight Bulbs on JK Jeep Wrangler    Pilot PL-360C Fog Lights    Jeep JK Wrangler Headlights and Foglights together

Headlights only with Phillips X-Treme Power H13, #9008 bulbs, then fog lights only, then headlights & fog lights together


Fog Light Aiming: It is important that these Pilot Fog Lights be aimed properly. They should light up the road directly in front of the vehicle, and should NOT blind oncoming drivers. I have these adjusted so that I can use them along with the headlights in normal driving, and I NEVER get "flashed" by oncoming drivers. If you get "flashed" by oncoming drivers, then you have them aimed too high.